Pothole Repair
- Clean area of vegetation, dirt, and surface debris.
- Apply SS-1H emulsified liquid asphalt tack coat to surface.
- Install hot mix asphalt over the deteriorated area.
- Compact and roll to a smooth finish.
Skin Patch Overlay Repair
- Clean area of vegetation, dirt, and surface debris.
- Apply SS-1H emulsified liquid asphalt tack coat to surface.
- Install approximately 1 ½ inches of hot mix asphalt over the deteriorated area.
- All edges will be feathered down and the patches squared off.
- Compact and roll to a smooth finish.
Partial Depth Asphalt Repair
- Cold mill areas to specified depth – usually 2″ to 4″ inches.
- Thoroughly clean area of all loose debris and vegetation.
- Apply SS-1H emulsified asphalt tack coat at the rate of .10 gallon per square yard.
- Install hot mix asphalt paving.
- Roll to a smooth surface.
Full Depth Asphalt Restoration
- Excavate areas to be repaired to the full depth of existing asphalt.
- Re-compact sub-grade.
- Apply liquid asphalt tack coat to all vertical edges of repair.
- Install (TBD) inches of hot mix asphalt base material.
- Tack coat surface of asphalt base course to provide proper binding of the new surface course.
- Install two (2) inch hot asphalt mix surface course.
- Compact and roll surface to a smooth finish.
Reconstruct Existing Parking Lots
- Reconstruct existing parking lot by removing existing asphalt pavement material to the depth of existing asphalt, plus rock base, if required.
- Stabilize base, if required.
- Compact parking lot to proper density and grade area for proper profile and drainage.
- Install rock sub-base, as required.
- Install new asphalt parking lot per specification.
- Compact and roll to a smooth finish.